Technoincubus Posted May 7, 2018 Share Posted May 7, 2018 How are your water release is placed in water Doesn't it not working when submerged? Link to comment Share on other sites More sharing options...
malloc Posted May 8, 2018 Share Posted May 8, 2018 8 hours ago, Technoincubus said: How are your water release is placed in water Doesn't it not working when submerged? It will work to fill the level that it is at, but it will not fill if the liquid level is higher than that level. Being at the top of the room like it is here in a closed loop there will never be a problem with it. Link to comment Share on other sites More sharing options...
Carnis Posted May 8, 2018 Share Posted May 8, 2018 I built it with 5 gaspumps. I only added the 3s buffer automation to the hydrogen pump and set it to run at around 850-900 atmo pressure. And a smart battery automation to release excess power generated if hydrogen is piping up. It is selfpowered and selfcooling (aquatuner needs its own powerplant), but not easy to setup, and if you run the thermosensor on the pWater too low, it will sometimes overcapacitate the hydrogen pumps and the batteries can get drained. 1960W with 5 pumps, so just below the 2k limit. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.
Please be aware that the content of this thread may be outdated and no longer applicable.