Automation wire bridge [edit] not a bug = not to be connected to building

[Argelle]

Automation wire bridge* bug? The 1 signal does not go through! bridge is 0 so generator isn't regulated.

(*search with these 3 words gives back no result)

[BlueLance]

This won't work. A bridge does not connect the stuff, it connects the wires. Try this, Place a wire underneath the bridge on top of the hydrogen generator. (You can build a single tile of automation wiring) this might work. If not move the bridge to the side by one and connect as usual

[JonnyMonroe]

Just now, BlueLance said:

This won't work. A bridge does not connect the stuff, it connects the wires. Try this, Place a wire underneath the bridge on top of the hydrogen generator. (You can build a single tile of automation wiring) this might work. If not move the bridge to the side by one and connect as usual

Single tile built this way should work. The same design works for power wire bridges.

[BlueLance]

I wasnt sure, but that helps to have a second opinion. 

[Kasuha]

The automation wire bridge only connects to automation wire, not to building outlets. So you need to build at least one bit of automation wire right under the bridge end.

And I think the bridge ends should not be buildable over building outlets anyway.

[Argelle]

Thanks a lot to clarify this, I should have read more carefully the tooltip stating "conecting wire section"...

[Lutzkhie]

you can actually make it work, you just have to put a single automation wire on top of the bridge