Jump to content

How to insulate space exposed rooms?


Recommended Posts

I can't seem to get the rooms near space to cool down properly, I add dry wall and tiles, after 20 cycles it's 100 degrees. What should I do to cool this area down? 5bcfd74211117_ScreenShot2018-10-24at1_18_22pm.thumb.png.1e16d98999c4c1a61e270e588cff2451.png5bcfd728b9f15_ScreenShot2018-10-24at1_18_27pm.thumb.png.3bd78e76ff4e16f12246fecf8debc3af.png

 

Very frustrating that I can't make steam in the top left room, but everything else is TOO HOT.

Link to comment
Share on other sites

First create a long wall (isolated or not you decide), under it vacuum whitout walls tile, then another wall. Then pump some hydrogen in the AETN. Replace the oxygen whit the hydrogen atmosphere at wizz and AETN for better cooling (over 2 kg / tile) 

Short answer. Your base is a mess :) 

Link to comment
Share on other sites

The heat is from the regolith on your roof. So :

1. Sweep all the regolith on your roof.

2. Unconstruct your hot roof and let the hot gaz leave in the space.

3. Construct a new roof (don't need to be insulated) and add a second roof above the first one separated by a tile of space where the regolith can stay without heat your room.

Link to comment
Share on other sites

- Vacuum separation between the top layer where the regolith accumulate and the rooms you want to cool down.

- Don't forget to sweep all the hot regolith inside those rooms because it's heating the floor. I can see many hot regolith piles nearby the wheezeworts.

- I suggest you build the telescope on mesh tiles because to my knowledge they won't transfer the heat from the nearby bunker tiles to the telescope.

Link to comment
Share on other sites

21 hours ago, teflon_gran said:

I can't seem to get the rooms near space to cool down properly, I add dry wall and tiles, after 20 cycles it's 100 degrees. What should I do to cool this area down? 5bcfd74211117_ScreenShot2018-10-24at1_18_22pm.thumb.png.1e16d98999c4c1a61e270e588cff2451.png5bcfd728b9f15_ScreenShot2018-10-24at1_18_27pm.thumb.png.3bd78e76ff4e16f12246fecf8debc3af.png

 

Very frustrating that I can't make steam in the top left room, but everything else is TOO HOT.

What is your gas pressure?  without any air in those rooms, the heat isn't going to go anywhere.  

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

Please be aware that the content of this thread may be outdated and no longer applicable.

×
×
  • Create New...