Jump to content

Does the puddle trick work with natural vents?


Recommended Posts

almost but not quite

the max pressure "sensor" is one tile up from the bottom

so for the puddle trick to work there needs to be a 999.9Kg layer at the bottom then a 2Kg layer above that

then the vent will keep erupting with the 5Kg pressure limit

HOWEVER even though it is erupting the pressure doesn't rise past 5Kg so this trick is pointless

hh.thumb.png.44b112ebbc4aef937733dcf6a761a13e.png

Link to comment
Share on other sites

I had some small amount of CO2 floating around at the bottom of my Methane Geysir. It somehow caused the pressure to rise indefinitely. Unfortunately I neither investigated the root of this beahaviour properly nor recorded it.

Link to comment
Share on other sites

2 hours ago, MTzu said:

I had some small amount of CO2 floating around at the bottom of my Methane Geysir. It somehow caused the pressure to rise indefinitely. Unfortunately I neither investigated the root of this beahaviour properly nor recorded it.

I had a vent that would just go up in pressure indefinitely even though the room had no other gases or liquids and only 4 wheezeworts and 1 gas pump
And another vent that was set up in the same way would stop at 5kg
Very odd but didn't care enough to post about it

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

Please be aware that the content of this thread may be outdated and no longer applicable.

×
  • Create New...