Jump to content

help needed for using minor volcano


Recommended Posts

so i have a minor volcano erupting magma 116kg/s at 2785 degree C so i have used this design to cool it and also use for power generation the problem is that the magma is turning into igneous rock which is blocking my volcano mouth now the whole setup is completely packed its hard to deconstruct and put robo minor there 

what i should have done instead

{90F2C4F6-5AC8-487A-A5DB-341C40AA2477}.png.jpg

if you have super coolant you could drop those inside...(first dig out that thing and fix those sour gas somehow)
I was avoid using it at first and try to keep it vacuum,but once I drop 200kg super coolant inside those rock drop temp much faster(I use for oil to pet setup)
it should bring the whole thing down to below 400 in between active cycle allow you to go in for digging(super coolant turn to liquid under 400~C
and conduct heat fast even in gas mode)it work better then water / oil since both thing hard to deal with once gas-ed

You could try ensuring that the magma is never above ~500kg/tile when it cools. For example by allowing it to spread horizontally on an insulated tile flat and only cooling it at the edges where it has already "flattened" into 100kg/tile.

When a small amount of magma cools, it cools into an item, not a tile.

You can then pick the item with a sweeper, or just leave it to slowly exchange heat with the diamond/thermium tile below it.

Archived

This topic is now archived and is closed to further replies.

Please be aware that the content of this thread may be outdated and no longer applicable.

×
  • Create New...