Masterpintsman Posted April 26, 2017 Share Posted April 26, 2017 Relatively simple setup: Running cost around 5w as the valve is set to short above 100g/s, just keep the water from freezing and your duplicants from taking (or vomiting into) it. Buildable without need for debug mode. Link to comment Share on other sites More sharing options...
Vilda Posted April 26, 2017 Share Posted April 26, 2017 Yeah, the part "not taking it" is a hard one. Link to comment Share on other sites More sharing options...
Ciderblock Posted April 26, 2017 Share Posted April 26, 2017 I don't think I get the point, why do this instead of just a wall and one or more airlocks? Link to comment Share on other sites More sharing options...
Kasuha Posted April 26, 2017 Share Posted April 26, 2017 5 minutes ago, Ciderblock said: I don't think I get the point, why do this instead of just a wall and one or more airlocks? Airlocks let gas through, expecially if dupes decide to stop in them to catch breath or to do something. A water column won't let any gas through while duplicants can pass through it with no problems. Link to comment Share on other sites More sharing options...
Vilda Posted April 26, 2017 Share Posted April 26, 2017 I find water airlocks annoying to setup and getting 10% stress for soaking wet not worth it. I usually use double airlock with one space between. It's not gas tight, but the leakage is quite small and if they need a breather one door stays closed. No need for a third door since the gas is no longer destroyed. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.
Please be aware that the content of this thread may be outdated and no longer applicable.