cOnSdOnG Posted February 16, 2018 Share Posted February 16, 2018 I built a little area where I mass produce oxygen but the oxygen isn't flowing through the pipes fast enough to satisfy my dupes Link to comment https://forums.kleientertainment.com/forums/topic/87691-how-would-i-move-gasses-through-pipes-faster/ Share on other sites More sharing options...
Soulwind Posted February 16, 2018 Share Posted February 16, 2018 More air pumps and pipes. Each pipe can handle 2 Pumps worth of packets before you start delaying things. Link to comment https://forums.kleientertainment.com/forums/topic/87691-how-would-i-move-gasses-through-pipes-faster/#findComment-1005073 Share on other sites More sharing options...
Saturnus Posted February 16, 2018 Share Posted February 16, 2018 Gas pipes have a maximum flow rate of 1kg/s. That equals two gas pumps. If you need more than that you need more pipes. Or you can liquefy the gas and move it as a liquid at 10kg/s through liquid pipes, and then evaporate and heat the gas up again in situ. Link to comment https://forums.kleientertainment.com/forums/topic/87691-how-would-i-move-gasses-through-pipes-faster/#findComment-1005074 Share on other sites More sharing options...
cOnSdOnG Posted February 16, 2018 Author Share Posted February 16, 2018 okay thanks guys Link to comment https://forums.kleientertainment.com/forums/topic/87691-how-would-i-move-gasses-through-pipes-faster/#findComment-1005078 Share on other sites More sharing options...
greggbert Posted February 16, 2018 Share Posted February 16, 2018 1) Seal up your base. If it leaking out the bottom you will not build up the needed pressure 2) CO2 scrubbing takes a lot of pressure out of your base. Set your CO2 scrubbers to only turn on if the pressure is above 1000. 3) If you have more than 2 air pumps worth of gas you need another pipe :(. 4) Sometimes algae oxydiser is better than a whole other set of pipes. Link to comment https://forums.kleientertainment.com/forums/topic/87691-how-would-i-move-gasses-through-pipes-faster/#findComment-1005152 Share on other sites More sharing options...
Xarian Posted February 17, 2018 Share Posted February 17, 2018 Use airflow tiles as much as you can so that the oxygen will travel through your base without using pipes. Diffusion in ONI is very sluggish, so it's best to stick your oxygen generator setup near the middle part of your base. Link to comment https://forums.kleientertainment.com/forums/topic/87691-how-would-i-move-gasses-through-pipes-faster/#findComment-1005197 Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.
Please be aware that the content of this thread may be outdated and no longer applicable.