Owlrust Posted September 26, 2021 Share Posted September 26, 2021 I wanted to make a DST-based 3d printed spinner ring and I'm trying to find designs for the spinner part that would look nice but I can't think of anything. The problem is that the center design juts out as part of the same solid-color filament so that limits some possibilities (meaning shapes are all that can be done). for example: I had a few ideas such as: Pig Head Spider Ham Bat Or maybe even a boss or something; but I am at a loss for what I could do that would represent the game well enough. The outside and spinner bands can be their own colors too so I wanted to consider that as well in case I wanted those to represent something. Any suggestions would definitely appreciated. Link to comment Share on other sites More sharing options...
Mike23Ua Posted September 26, 2021 Share Posted September 26, 2021 Easy, the series classic dark purple and black colors from original DS.. and then just Wilson’s head. like all these emotes we have: Link to comment Share on other sites More sharing options...
BezKa Posted September 26, 2021 Share Posted September 26, 2021 Clout Snout Nightmare Fuel Top Hat Tragic Torch (without the flame) Terrorbeak And that's all that comes to mind for now. I'm just spitballing, so sorry if these are no good. Good luck on your project!!! Link to comment Share on other sites More sharing options...
Cheggf Posted September 26, 2021 Share Posted September 26, 2021 Can you do more than one picture? I think a loop of the three stat badges would look good. If not Wilson's hair and the ham bat are also good contenders. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.
Please be aware that the content of this thread may be outdated and no longer applicable.