yoakenashi Posted February 5, 2020 Share Posted February 5, 2020 Power lines, pipes, and ducts all appear on top of their respective buildings when their respective overlays are opened. This makes it easy to see where the lines/pipes are connected. However, the conveyor overlay does not behave this way and makes identifying how the conveyor rails are connected impossible. See screenshot below. I cannot see how these buildings are connected. The only option is to deconstruct all the rails and then rebuild them. Link to comment Share on other sites More sharing options...
MrGuga Posted February 29, 2020 Share Posted February 29, 2020 I agree. It's not reasonable to hide rails in the rail overlay... Link to comment Share on other sites More sharing options...
RonEmpire Posted March 7, 2020 Share Posted March 7, 2020 Pipes also has issues as well since they don't actually touch the green or white boxes. They need to over lay as well on top of the vents and output input so show boxes connection Link to comment Share on other sites More sharing options...
RonEmpire Posted March 12, 2020 Share Posted March 12, 2020 heres an example where you can't tell if the pipes are connected where that red line is. You can roll over the tiles and see there are pipes. BUT there is NO visual indication on if they're actually connected or not to each other or just two pipe by itself. Link to comment Share on other sites More sharing options...
Andreas45 Posted March 15, 2020 Share Posted March 15, 2020 I hope this gets addressed soon. I couldn't figure out what has happened to my pipes after this last update. And just in case there was still any doubt, here's some more examples. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.
Please be aware that the content of this thread may be outdated and no longer applicable.