jfc Posted September 5, 2018 Share Posted September 5, 2018 Been over 4 cycles already and still nothing... s Link to comment Share on other sites More sharing options...
Saturnus Posted September 5, 2018 Share Posted September 5, 2018 Try save-reload. Otherwise it might another ninja update not mentioned in the update notes that Klei all but promised they wouldn't do anymore. Link to comment Share on other sites More sharing options...
jfc Posted September 5, 2018 Author Share Posted September 5, 2018 They finally spawned, pretty sure they spawned much faster in like 1 cycle or 2, it took around 8-10 cycles Link to comment Share on other sites More sharing options...
Saturnus Posted September 5, 2018 Share Posted September 5, 2018 11 minutes ago, jfc said: They finally spawned, pretty sure they spawned much faster in like 1 cycle or 2, it took around 8-10 cycles It was one every 3 cycles before. On the second. Link to comment Share on other sites More sharing options...
RonEmpire Posted September 5, 2018 Share Posted September 5, 2018 What you need to do is make sure your automatic clock doesn't just open and close the doors until a morb spawns. I had my clock on an open close timer for night time and it kind of resets the spawning of the morb. That caused it not to spawn. Somebody had a pressure plate automation for when a morb goes on it and it triggers the floor opening, that actually worked. I left it alone for a few cycles and I think I have over 100+ morbs now and my PO2 pressure has gone up to 24k per tile. ugh. It's lagging like hell right now. I think I might have to go kill them off drowning them or something. Link to comment Share on other sites More sharing options...
goatt Posted September 5, 2018 Share Posted September 5, 2018 3 hours ago, RonEmpire said: I have over 100+ morbs now and my PO2 pressure has gone up to 24k per tile is the PO2 pressure naturally 24k? cuz mine stops at 1k, they stop spitting PO2 at 1k. Link to comment Share on other sites More sharing options...
RonEmpire Posted September 5, 2018 Share Posted September 5, 2018 the trick is to have them soaked in polluted water on the floor. it is some what of an exploit I guess. you're cheating the max gas pressure because they're in the same tile as a low pressure water. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.
Please be aware that the content of this thread may be outdated and no longer applicable.