Jump to content

How to use the Manual generator ?


Recommended Posts

You place it down, then put something that requires power next to it and then you place electrical wire between the two (icons will appear when placing wires that tell you where the outlets are). Then a dupe will automatically run on it to charge the connected devices. It helps to put a battery in there too, so they don't have to run all the time.

@ArkhamTwins: Mine out some algae, they should put it in the oxidizer, at which point someone should man the generator. You could also connect up a battery, they will use the generator to charge it. Probably best to do both.

@Zezarict: I've asked myself the same question. I'm not sure it actually does anything at the moment.

4 hours ago, Zezarict said:

While on this topic, anybody know exactly what the threshold bar means? I'm guessing it's battery percent left/battery percent used, but it seems like they use it either way.

When the batteries are fully charged up, the dupe will be thrown off the generator. They will then wait until the battery depletes to the threshold level before getting back on and charging it back up. This stops the dupes from continually getting on and off the generator to top off the last % of battery whenever power is being used.

15 hours ago, PaulV said:

@ArkhamTwins: Mine out some algae, they should put it in the oxidizer, at which point someone should man the generator. You could also connect up a battery, they will use the generator to charge it. Probably best to do both.

@Zezarict: I've asked myself the same question. I'm not sure it actually does anything at the moment.

They're using the generator, they just build and leave it there. This is how it looks.

20170301101553_1.jpg

20170301101556_1.jpg

@ArkhamTwins: The two devices are not connected, you need to click and drag a wire from one to the other. I think you may have just clicked to place a wire on each spot, which does place a wire, but doesn't connect the two together (this is so that you can put two lines parallel to eachother without them connecting everywhere). If you put a space between the two devices, this is more obvious.

Archived

This topic is now archived and is closed to further replies.

Please be aware that the content of this thread may be outdated and no longer applicable.

×
  • Create New...