Sebastiangperez Posted July 10, 2021 Share Posted July 10, 2021 sometime if you have to extract liquid from a pipe you need to use the the extract pipe tool , but if you only need to extract just one tile , this function keeps going and stuck in the same place. maybe if is one time job, will be great. Link to comment Share on other sites More sharing options...
degr Posted July 11, 2021 Share Posted July 11, 2021 15 hours ago, Sebastiangperez said: maybe if is one time job, will be great. no Link to comment Share on other sites More sharing options...
Sebastiangperez Posted July 11, 2021 Author Share Posted July 11, 2021 20 minutes ago, degr said: no Troll Link to comment Share on other sites More sharing options...
degr Posted July 11, 2021 Share Posted July 11, 2021 In almost all cases I need to extract all pipe content, and if I set errand nearby liquid or gas bridge, all content will be extracted in same point. So, from my opinion extract pipe content as single errand is big nono Link to comment Share on other sites More sharing options...
Sasza22 Posted July 11, 2021 Share Posted July 11, 2021 It would work if it followed the pipe content and wasn`t attached to a pipe segment. Most of the time i want to remove the pipe content is when i get something in a pipe that isn`t supposed to be there. If i could mark that and it was attached to the packet following the pipe movement then it would work as a one time job. But if it just empties the selected pipe segment then it`s better as a continous job as i can get sure all the stuff below that point gets removed. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.
Please be aware that the content of this thread may be outdated and no longer applicable.