Tobruk Posted May 15, 2020 Share Posted May 15, 2020 A sensor that would detect whether packets inside the gas/liquid/solid pipe are moving or not. Link to comment Share on other sites More sharing options...
pether Posted May 18, 2020 Share Posted May 18, 2020 Didn't check this, but it might work: Split pipe into 2 flows. Instal 2 sensors in 1 pipe, connect one of them to NOT gate and then link both outputs to AND gate. Ofc in the end merge both pipes back into 1. Link to comment Share on other sites More sharing options...
Sasza22 Posted May 19, 2020 Share Posted May 19, 2020 On 5/18/2020 at 2:02 PM, pether said: Didn't check this, but it might work: Split pipe into 2 flows. Instal 2 sensors in 1 pipe, connect one of them to NOT gate and then link both outputs to AND gate. Ofc in the end merge both pipes back into 1. Would be probably easier to use a bridge in the middle of a pipe. If the liquid flows normally all goes into the bridge. If it`s not it will go further down the pipe. A single sensor there would work. The pipe would then cycle back and once the flow is reasored it will empty. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.
Please be aware that the content of this thread may be outdated and no longer applicable.