Jump to content

pipe element sensor


Recommended Posts

Temperature sensor not work like this? If you setup pipe temperature sensor and set temperature to "below -272C"(or "above -273C") it should trigger for any stuff in pipe which temp above -273C(which is anything except liquid helium), and empty pipe considered as -273C, so in 99.9% cases you could check if pipe empty or there something(any gas/liquid) inside.  Not sure how right now, but some time ago this worked.

Link to comment
Share on other sites

1 hour ago, D.L.S. said:

Temperature sensor not work like this?

I remember they changed it some time ago so that the temp sensor remembers the temperature of the last packet that came through. Even though it shows absolute zero when there`s nothing in it sends the automation signal based on the last packet that passed it. I don`t think it changed since then.

Seems like they intended it to not be used to detect if stuff is in the pipes.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

Please be aware that the content of this thread may be outdated and no longer applicable.

×
×
  • Create New...