strawberrygirl Posted June 11, 2017 Share Posted June 11, 2017 Is there any reason why I cannot connect these pipes to the main line? Every time I do, the water stops pumping. Seems like any point where there is a pipe going in 3 directions its not working but there is one other place in my base it works just fine. I'm not trying to attach both, was just trying to make at least one of them work but both have the same result.. the water stops. Can't have that because its feeding my oxidizers. Please see attached. Link to comment Share on other sites More sharing options...
Masterpintsman Posted June 11, 2017 Share Posted June 11, 2017 The issue you have is that you add a loop, which confuses the pipe logic into no longer knowing in which direction the packets should flow. Use pipe bridges (which break up the pipe for the code into smaller, individual segments) to force the packets in the direction you want them to go. Link to comment Share on other sites More sharing options...
Townkill Posted June 11, 2017 Share Posted June 11, 2017 put a valve or a bridge from the main pipe to the extension Link to comment Share on other sites More sharing options...
strawberrygirl Posted June 11, 2017 Author Share Posted June 11, 2017 Ok thanks guys! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.
Please be aware that the content of this thread may be outdated and no longer applicable.