CreativeBox.exe Posted January 22, 2018 Share Posted January 22, 2018 I placed 2 Heavy Watt Joint Plate so close to another that the two joints at the end are touching, but it doesn't look like they are transfering any power. They are connected, but even when I place them elsewhere it doesn't work. The ones over the doors, already tried to place the left one one block higher: Link to comment Share on other sites More sharing options...
Saturnus Posted January 22, 2018 Share Posted January 22, 2018 They can't be connected end to end like that I'm afraid. Link to comment Share on other sites More sharing options...
CreativeBox.exe Posted January 23, 2018 Author Share Posted January 23, 2018 Yeah, but this doesn't work either. Link to comment Share on other sites More sharing options...
Kabrute Posted January 23, 2018 Share Posted January 23, 2018 rebuild the bottom one cuz you bugged it by layering its connection point with another connector this broke that connector, replacing the other one didn't fix this one. Link to comment Share on other sites More sharing options...
Saturnus Posted January 23, 2018 Share Posted January 23, 2018 3 hours ago, CreativeBox.exe said: Yeah, but this doesn't work either. run the normal wire through the wall not over the heavi-watt. You can run it through the the joint plate. Link to comment Share on other sites More sharing options...
Kabrute Posted January 23, 2018 Share Posted January 23, 2018 I don't see the point in any hw wire if hes running normal on the same line o.o Link to comment Share on other sites More sharing options...
CreativeBox.exe Posted January 24, 2018 Author Share Posted January 24, 2018 No that was a bug, fixed it. I shows that it's connected, but it doesn't transfered any power. Link to comment Share on other sites More sharing options...
Kabrute Posted January 24, 2018 Share Posted January 24, 2018 If you only rebuilt 1 joint plate then you did not fix the bug Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.
Please be aware that the content of this thread may be outdated and no longer applicable.