komodotwo Posted November 19, 2017 Share Posted November 19, 2017 Does anyone have any screen shots of how they set the plates up? The info says they can buffer or increase heat lose Link to comment Share on other sites More sharing options...
Michi01 Posted November 19, 2017 Share Posted November 19, 2017 56 minutes ago, komodotwo said: Does anyone have any screen shots of how they set the plates up? The info says they can buffer or increase heat lose You just use them to connect two areas that you want to quickly transfer heat between. Link to comment Share on other sites More sharing options...
CasualRaz Posted November 19, 2017 Share Posted November 19, 2017 Link them up like a chain but remember the material you make them out of makes a huge difference to the effect Link to comment Share on other sites More sharing options...
Lifegrow Posted November 19, 2017 Share Posted November 19, 2017 I just slap a load of them down in the area I want heat to be dispersed within, not sure if theres any science behind differing layouts, etc Link to comment Share on other sites More sharing options...
Kabrute Posted January 7, 2018 Share Posted January 7, 2018 they connect to each square around them, 3x3 so 9 spaces, I have seen them shove abysalite thermal tiles around. If you have a super cold floor and a hot machine put shiftplates behind the machine along the floor, this will share the buildings heat with the floor directly, so far they don't really affect each other except in gasses so plate gas plate, vacuum test show they maintain insulation 90% of the time. They have an extreme amount of mass so you can use them as a stabilizer, rapid shifts in temp will take time to get around them as it were. Otherwise you can use it to disperse the heat of a building into the suroundings as mentioned above. Link to comment Share on other sites More sharing options...
Etiam Posted January 7, 2018 Share Posted January 7, 2018 11 hours ago, Kabrute said: If you have a super cold floor and a hot machine put shiftplates behind the machine along the floor, this will share the buildings heat with the floor directly, so far they don't really affect each other except in gasses so plate gas plate, vacuum test show they maintain insulation 90% of the time. Tempshift plates never share heat with buildings directly (unless its a door) not even with other tempshift plates. Instead this will conduct the heat from the gas heated up by machine to the floor. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.
Please be aware that the content of this thread may be outdated and no longer applicable.