Jump to content

Improvement of Thermo Sensor

Recommended Posts


Can you extend the Thermo Sensor to have radio buttons on what exactly to measure:

  • The Gas/Liquid Temperature on its tile
  • The Liquid/Gas Pipe on its tile
  • The Liquid/Gas Pipe content on its tile
  • The construction to its left/right/up/down position. 

At the moment it only tests for the gas/liquid temperature of it's tile and that is quite limiting, as to measure the temperature of pipe content I would have to release it and then pump it in again. And some buildings get much faster hot than the gas surrounding them and that makes it hard to measure that temperature.

While I'm here, a Gas/Liquid Type sensor might be interesting, too.

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

Please be aware that the content of this thread may be outdated and no longer applicable.

  • Create New...