Looking for H generator designs!

[ShamPeiN]

 

13 hours ago, Fatmice said:

That made no sense.

the point of hydrogen generator is not power making, mostly to getting rid of hydrogen, even on high density 1 tile of hydrogen is like 15 sec, so makes 480kj daily(12 batteries) best case, from 60kg hydrogen which is 20? tiles 

usually a setup to process hydrogen needs lot of time to build  power generated doesnt worth it, with a high room, storing it, a thermo switch can turn on a pump by setting on high value, off when condition switched(when low on hydrogen), so store in a room like 3x7 minimum (fits ladders, but can be 2x10) electrolyzer can push oxygen downward, hydrogen wont go down, no filter needed, not the most optimized but still better than using tons of pumps and filters, also more electrolyzers can be placed but wont cost more energy, just resources, powering 2 electrolyzers 4 pumps and 2 filters still stops  sometimes and because slow airflow, kinda better to spread oxygen producing, than distributing from a centralized location

1 hour ago, Grimgaw said:

Made some sense to me.

When you switch tepidizer on it heats up then checks for submersion.

You can therefore use the 'manual' switch to turn it off and on repeatedly in quick succession to get stupid high temps.

yes, tepidizer turns on for few seconds and goes on cooldown, but turning off after animation allows turning on again

bellaaner on twitch stream did this with the ONI211704 version, the tepidizer made like 2500 celsius in an insulated room, converted algae into dirt then sand then melted the amalgam tepidizer itself into liquid gold

on *867 version machines dont overheat themselves that much

[MoMuffins]

10 hours ago, ShamPeiN said:

a thermo switch can turn on a pump by setting on high value, off when condition switched(when low on hydrogen)

I can see you set the thermo switch to like "colder" than some high temperature, like 300 C, to turn on the pump, but I don't see how that will turn off the pump when it is low on hydrogen.  The pump will keep pumping in whatever gas is around, oxygen in this case.  There is only one use case where I think of using the thermo sensor to turn off circuit is if the two gasses are of two different temperature.  One could cool the oxygen while heating the hydrogen with the space heater.  Given enough mass, the temperature change will be slow enough such that the gradient can be used to sense the gas level to toggle the pump dedicated to hydrogen.

10 hours ago, ShamPeiN said:

yes, tepidizer turns on for few seconds and goes on cooldown, but turning off after animation allows turning on again

Yeah this is some manual exploit fun, but not very useful for anything, maybe to boil algae into dirt to make some made-to-order natural tile.

[ShamPeiN]

you kill me, thermo switch colder than 300=on, you click on it warmer than 300=off

you can check levels and set machines manually

[MoMuffins]

2 hours ago, ShamPeiN said:

you kill me, thermo switch colder than 300=on, you click on it warmer than 300=off

you can check levels and set machines manually

Oh, manually.  Meh, I keep thinking you were talking about automatic.  That's a pain.

[ShamPeiN]

6 hours ago, Fatmice said:

Oh, manually.  Meh, I keep thinking you were talking about automatic.  That's a pain.

2 clicks, still better than valves

but yes, some sensors would be nice, also better pumps and more power from machines

[Lafara]

I wish there is Atmospheric Sensor ... enable when gas concentration >1000g.

Vacuum , mg gas , mcg gas alway damage gas pipe system T_T