Jump to content

Add Automation to Analyzed Geysers.


Recommended Posts

Output Behaviour:

Sends a Green Signal when active.  Otherwise (when Dormant) sends a Red Signal. 

The automation slot can be added right under the the added sensor.  Perhaps additional analysis time or material cost could be required but that's not necessary.

I think this would be an awesome addition that would allow for easier geyser taming as well as finer control of other systems.  For example if the water geyser is dormant than the pump in the secondary tank or a desalinator is allowed to operate.

Link to comment
Share on other sites

4 hours ago, sakura_sk said:

Volcanos can't possibly have automation touching liquid metal/rock. Any other vent/geyser can use the bridge priority or gas/liquid sensor.

You can build automation out of tungsten so that would work for anyting colder than a tungsten or niobium volcano.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

Please be aware that the content of this thread may be outdated and no longer applicable.

×
  • Create New...