Jump to content

intake vent for liquids

Recommended Posts

Easiest way I can think of implementing something like this would be to measure water height above the intake and setting the pressure in your pipe based on this. If you wanted to make things more complex, water can only enter a segment of pipe if it height of the pipe is less than the current height of the water reservoir

Link to comment
Share on other sites

You could introduce something like a water/gas "Tap/Faucet" if you will. A device you could stick through a wall in any direction without breaking the block and allowing the gas/water to escape through the hole while the dups build something to replace the block. Perhaps adding a new "drilling" technology or something to that effect.

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

Please be aware that the content of this thread may be outdated and no longer applicable.

  • Create New...