Valmighty Posted October 28, 2020 Share Posted October 28, 2020 Due to limited power/wire, I want to switch around between oil refinery and liquid pump that pump the oil. The condition is simple: if crude oil is detected, run the refinery and shut down the pump (using not gate at the other end). As you can see, i already set the sensor to "crude oil", but it's still sending red signal instead of green. What do i do wrong? Link to comment Share on other sites More sharing options...
OxCD Posted October 28, 2020 Share Posted October 28, 2020 @Valmighty you're using environmental sensor, instead of liquid pipe sensor. Use this one : Link to comment Share on other sites More sharing options...
Valmighty Posted October 28, 2020 Author Share Posted October 28, 2020 OMG silly me. Thank you so much! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.
Please be aware that the content of this thread may be outdated and no longer applicable.