Jump to content

Colors on logic activation parameter sliders


Recommended Posts

Your coloring between the sliders is not always accurate. In your example, when the output is between 30 and 70, it's color is determined by whether the low threshold has been triggered.  If it's on its way down from 70, it's red, but if it's on its way up from below 30, it's green.  However, if it's on it's way back up without going below 30, it's still red.  Representing a hysteresis with just 2 colors is challenging.  Perhaps use a single bar with a sloped color transition between the sliders?  Something like the attached image.  However they do it, it's going to remain confusing for the uninitiated.

 

image.png

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

Please be aware that the content of this thread may be outdated and no longer applicable.

×
×
  • Create New...