Wire Bridges overloading when going over the maximum Potential Load while not actually going over the max Current Load

1. you have potential load of over 25KW on your wire, which can only handle 2k. So it will draw way more than 2k at some point, and thats your failure then.

2. dont mix heavy watt and smaller wires. This causes all sorts of problems. Use transformers.to geht from high power cables to low power ones. Dont connect them directly. The whole circuit is handled as one and the same. If the high-power line will drain >2k so will the low power ones at the same time. Thats how the system works.

On 5/23/2020 at 11:15 PM, SharraShimada said:

1. you have potential load of over 25KW on your wire, which can only handle 2k. So it will draw way more than 2k at some point, and thats your failure then.

2. dont mix heavy watt and smaller wires. This causes all sorts of problems. Use transformers.to geht from high power cables to low power ones. Dont connect them directly. The whole circuit is handled as one and the same. If the high-power line will drain >2k so will the low power ones at the same time. Thats how the system works.

Yeah, I ended up figuring it out when I build another one and it overloaded once the 8 dupes I had used their doors at the same time, that that was where it was using more power than it could handle, because it's literally the only thing that I had at that point so I thought it was buggy.

 

Thanks for the tip.