Memory Toggle Issue - Placing a Signal Switch anywhere in the map is setting output as 1

Hi, in the image you've posted it looks like you've got a not gate outputting a 1 to the "set" port of the memory toggle. This means the memory toggle will output a 1 as well.

Just guessing from the image, it doesn't look like the signal switches have any effect on that particular situation.

On 5/8/2018 at 2:26 AM, JLK said:

Hi, in the image you've posted it looks like you've got a not gate outputting a 1 to the "set" port of the memory toggle. This means the memory toggle will output a 1 as well.

Just guessing from the image, it doesn't look like the signal switches have any effect on that particular situation.

Yes. In this pic its giving 1 to the S port of the toggle. That's not the bug.

If you look closely, the reset port will be connected in an output loop with a delay of 5 sec. After the output sends 1 continuously for 5 seconds, the filter gate will output 1 to the reset port thereby resetting everything

Now, after reset, when you place a signal switch nearby, it causes the memory toggle to output 1 even though it was outputting 0. This is the error I mentioned.