Jump to content
Rotwood Coming to Steam Early Access April 24

Liquid Valve not working

mrbunnyban

By mrbunnyban

    • Pending

The Liquid valve is not reducing the flow of water to the amount I specified. The water exitting the valve reads at 10kg instead of 1000g/s

 I think it may be that I did not immediately reduce the flow of water going out of the valve at first. I suspect the game may be remembering the original amount I had set the valve to and is stuck on that value, much like how the gas fileters would be stuck on a speciic gas bug previously.

Steps to Reproduce
Valve was the last thing I constructed in the setup I have. However, I left the water flow at 10kg/s at first, and only later after the water already started flowing into my electrolizer did I set it to 1000g/s.
Go to bugs

User Feedback


mrbunnyban

Stupid internet connection double posted. Anyway, the workaround I tried based on my guess was to load a save before the valve was created, and made sure to set it to the amount I wanted before any water went through. It worked.

Share this comment

Link to comment
Share on other sites
mrbunnyban

Guh, bug is back again. Since this is long past the point I created the valve, I can't just reload a game where I never made the valve as a workaround this time.

Share this comment

Link to comment
Share on other sites
Balavac

Had the same issue, turned off the pump, emptied the pipes, then turned the pump on again. Worked for me. Hope this helps.

Share this comment

Link to comment
Share on other sites


Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...