Gas thermo sensor broken

The pipe thermo sensors are keeping their state when there are no gas inside. If you put a gas below the threshold, it will output red until another pocket of gas is above the threshold. 

 

It prevents flickering. 

then maybe it shouldn't say -273 maybe something like "null" would be better? or "No Gas" or why not just the temp of the tube? flickering?

Edited August 11, 2019 by trinitas

Changed Status to Known Issue

Yes, we found in practice it was much better if it "held" its last reading in case there were gaps in the pipe contents. Thus, this sensor becomes more useful to answer "what is the temperature of the gases in this pipe" rather than "what is the temperature of the exact packet under the sensor".

What is the particular problem you're trying to solve here?

it's -273 even when oxygen is in the pipe. Just place a thermo sensor on a bridge and you will see this (bug(?))

Edited August 15, 2019 by trinitas