After the recent update, I found that my lavatory and shower plumbing output wasn't working -- polluted water would clump up at the end of the pipe instead of flowing towards my fluid holding structure. In fact, I could see small amounts of polluted water flowing backwards from the sinks towards the backed-up end where the showers were.
Overnight I designated to disconnect the pump on the same circuit (also intended to flow towards the fluid holder) and reroute the polluted water to the vessel on a dedicated pipe, and also for good measure to deconstruct all of the pipes leading out of my lavatory/shower area so I could rebuild them. However, in the morning the client crashed during that deconstruction.
The crash reporter process hung in a busy loop, so I'm reporting manually.
Also, this bug reporter has inaccurate information on where output.log is but I eventually found it in AppData.
Load the attached save and run until crash.
A developer has marked this issue as fixed. This means that the issue has been addressed in the current development build and will likely be in the next update.
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now