David13 Posted September 2, 2017 Share Posted September 2, 2017 I tried to rig it so many ways already but it just doesn't work and I don't know why. For a while it seemed like it worked but then I had to reload cuz I left it unpaused while alt+tabbed and after the reload it stopped working and it's not just because it takes a while to load all the stuff up, I resumed for a while and nothing happens they just don't work. Only one out of 3 works and I have no idea why. As you can see there's TONS of gas in the pipes and there's more than enough room for the CO2 to go. There's room for the water and for the electricity (on 3 of them the 4th is not fully built yet). The middle two are the ones that do not work. The rightmost works and the leftmost is not finished yet. I linked 3 screenshot with each layer showing that it's fully connected and it doesn't pump. They are not disabled either. If you have any ideas on what causes this problem, please help. Link to comment Share on other sites More sharing options...
Michi01 Posted September 2, 2017 Share Posted September 2, 2017 I think you need to build the CO2 pipe like this: Link to comment Share on other sites More sharing options...
David13 Posted September 2, 2017 Author Share Posted September 2, 2017 51 minutes ago, Michi01 said: I think you need to build the CO2 pipe like this: Seems to work now with this CO2 setup, thanks. Seems rather odd that it didn't before. Link to comment Share on other sites More sharing options...
Jcheung Posted September 2, 2017 Share Posted September 2, 2017 It's because the little packet of co2 was blocking the output of the others. Same deal for showers and toilets fyi. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.
Please be aware that the content of this thread may be outdated and no longer applicable.