RedSteel Posted April 12, 2020 Share Posted April 12, 2020 If you combine a bunch of wires from different automation buildings, they function as an OR. If a single output gives a GREEN, then the signal on wire is GREEN. However, when the signal is GREEN, it also changes the colour of the OUTPUT's of all automation buildings on the same wire. Imho, the colour of the output tile should not change, even if the wire changes. Attached image shows how on a single wire there are 3 RED outputs and 1 GREEN. However, visually all outputs are shown as GREEN. Proposed solution: - Show outputs in outputted signal - Show wire in resulting colour (in example, as green) Why reported? Current visuals make it hard(er) to debug where in the automation setup a signal is coming from. The above state, also shown below with info card, amplifies this, where a green output is said to output red: Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.
Please be aware that the content of this thread may be outdated and no longer applicable.