The automation that checks the temperature seems to send a signal based on old data.
This should check the temperature of the liquid inside the pipe but it is slow to react
I just have a pipe with cold brine that is used to cool down an area, and when it gets hot enough to be turned into water without braking the pipe (above 0 celsius) it gets flushed out of the cooling loop, the automation however is not working
I can assure you the brine does not come from the pipes below, that is another cooling loop and it only contains polluted water [it is also used to cool the enviroment until it (the polluted water) becomes hot enough to be turned into regular water, same sistem as the brine sistem]
I just have brine that is slowly heated by the enviroment and should get dumped out of a cooling loop, the automation is powered and connected normally, no special steps required.
My laptop is very slow maybe it is not calculating the correct signal when at 3 speed?
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now