Switch with liquid pressure sensor

[Mr. Tropical]

I was wondering if anybody can help me out on how to set up a switch by the use of liquid pressure sensor. For example when it reaches 1 sensor the pump active but when it reaches the other sensor it deactivates.

Any Helps??

[blakemw]

Wrong forum (should be in general discussion), but this is where you want a Memory Toggle, AKA S/R Latch, it does precisely what you want.

You send a green signal from the "ON" sensor into the "S"ignal port on the Memory Toggle, this causes the memory cell to send a continuous green signal out the output port until it receives a green signal into the "R"eset port.

You send a green signal from the "OFF" sensor to the "R"eset port on the Memory Toggle, this causes the memory cell to send a red signal until it gets a green signal in the "S"ignal port.

So it'd look something like this: