Jump to content

Geothermal Heat Pump Doesnt Send Gas to Vent After Pumping Once and at 100% Pressure

Germany08

By Germany08

    • Branch: Live Branch Version: Windows Fixed

After the geo vent spews the steam out once, the geo pump does not send more steam to erupt. Below are attached screenshots:(it also appears to be consuming a small amount of liquid)image.png.eb074a8387d5bab89a6b9d5cd8bee15a.pngimage.png.faee2c34db40999d428d27f3d457fe66.png

Steps to Reproduce

Fill geothermal heat pump with polluted water and salt water, and activate.

Go to bugs

User Feedback


A developer has marked this issue as fixed. This means that the issue has been addressed in the current development build and will likely be in the next update.
HarryMcCleave

Thank you, should be able to have a fix for this in the next hot fix (the controller in your save gets stuck in a state that is too full to accept more material, but not full enough to vent (short 130 mcg).

Share this comment

Link to comment
Share on other sites
Germany08

Thank you so much. Have a good day

Also I just noticed that the reason it didnt have enough liquid to  begin with was because it is off gassing. But covering the bottom layer in water fixed that problem.

Share this comment

Link to comment
Share on other sites


Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...