Engie's tune up getting stuck


cpy
  • Branch: Preview Branch Version: Windows Pending

When my power is maxed and batteries jump on and off engineers stop tuning up and start from scratch, and don't finish tuning up the powerplants.


Steps to Reproduce
Have higher power usage than your powerplants cant produce, and let engineer tune it up.

Status: Pending

This issue has not been confirmed by a developer yet.


  Report Bug


User Feedback


.... .... .... ....

You guys can use "Duplicant Motion Sensor" to detect if a dupe is tuning up so your generators keep working and they can finish the job.

motion_sensor.png

Share this comment


Link to comment
Share on other sites
....

"Duplicant Motion Sensor" is't a solution for me... duples still trying and trying to tune up, but the process is interrupted contantly... some times they made it. I still thinkings that's a bug. I have 700hours of these, i never see before.

Share this comment


Link to comment
Share on other sites
....

I am also seeing this exact same problem, my dupe has been trying to tune-up the same generator for several cycles now, doing nothing else and constantly interrupted by...  nothing?

Share this comment


Link to comment
Share on other sites
.... ....

You are right. Doors need to be set to "open" and not to "auto" for Engie's Update to not cancel in the middle. It doesn't make sense - but it was the only thing that fixed it.

My tinkerer had +21, gas was 100%, CO2 was 100% not -blocked, and Engie would cancel about 50% through and my tinkerer would try again and again and again...

Share this comment


Link to comment
Share on other sites


Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now