Jump to content

Thermal Update Guide


Recommended Posts

 

옷입.png냉기.png내복.png

I can finally wear clothes.

 

옷.png

식물.png

1 Thimble Fiber = 1000g

"Thimble reed" is only in "green zone"

 

 

온도조절.png

Now the buildings we build are also affected by heat.

Let the steam of "Geyser" liquefy with water and lower the temperature.

The "Geyser" is so powerful that it is enough to keep one stable.

 

 

냉매.png

Water cooled cooling is best when cooling the building.

 

"Mealwood" no longer provides seeds at harvest.

Let's cultivate "Bristle blossom" with supply stable fertilizer.

Mealwood (10kg/1000cal)  : 5, 2.5, 2.5

Bristle blossom (1kg/1000cal)x2 : 10, 2, 2, 2, 2

//Fertilizer is consumed only in the first "Growth" and not in "Regrowth".(2kg / 18Cycle)

 

 

Cold or heat can cause injury and loss of health and disease.

 

 

문.png

"Mechanzed Airlock" now has permission to set.

 

 

빙하.png

"Liquid Tepidizer" only goes up to 85 degrees.

"Space Heater" may be 30 degrees

 

 

해치.png

"Hatch" consumes 3 times 50 kg each of every 10 seconds and provides 125 kg of coal.

I fed a large amount of contaminated ice in the "blue zone". There are still many. Coal accumulates incredibly quickly.

 

 

보관.png

Vacuum is a good storage method.

If you do not refrigerate, the food will be "Rotten * " due to food damage from about 20 degrees to about 10 cycles.

"Rotten * " going to Polluted dirt

 

 

To be honest, the "Geyser" was so good that the game became easier.

 

my Colony

베이스.png

베이스 기체.png

베이스 온도.png

베이스 파이프1.png

베이스 파이프2.png

Link to comment
Share on other sites

Can be planted on sand or any material that plants grow on.  You just need to cause sand to fall.  Also, it needs some atmosphere to grow otherwise it will not start the count down.  It takes about 4 cycles, give or take some, to grow.  It likes to live between -68C and 92.5C.  However, if the atmosphere is below 500g, it can cool that gas down to at most -178C without stiffling.

Link to comment
Share on other sites

3 minutes ago, Fatmice said:

What do your eyes says now? ;)

The difference with me is that I always stockpile enough fertilizer.

Always stockpile

It is consumed only when newly growing.

비료.png

 

It is no longer consumed in the present state. Until all of them are harvested.

Link to comment
Share on other sites

I stocked each with 50 kg of fertilizer, which is more than enough.  If it was the case that it doesn't need fertilizer after the first 10 cycles, then where did the other 30kg went?  My picture provided all of the evidence that refute what you claim.  It should still be growing.  You should check again.  In any event, it is likely a bug that you see.

 

Link to comment
Share on other sites

7 minutes ago, sai05 said:

hey bro . how did you trap 3 hatch ? and can you show me how glysier work ? thanks :) 

 

In fact, I restarted until I got a lot of hatch maps.

3 There was a map that came out with a hatch, so I started with that map.

And if you keep it, you keep eating every 10 seconds without hiding.

 

Geyser..

가이저.png

map.png

Red line : power swtich

blue line : hot water

orange line : Cooling route

map2.png

Link to comment
Share on other sites

23 minutes ago, Eternalguard said:

check my video

Looks like your planters are bugged.  They shouldn't do that.  Clearly they use 2kg/cycle.  Before they used even more, so I highly doubt what you see is what's intended.  Currently, they already use quite less than what they used to use so any less would be absurd.

Link to comment
Share on other sites

4 hours ago, Eternalguard said:

 

In fact, I restarted until I got a lot of hatch maps.

3 There was a map that came out with a hatch, so I started with that map.

And if you keep it, you keep eating every 10 seconds without hiding.

 

Geyser..

가이저.png

how you trun steam into water ? 

 

 

Link to comment
Share on other sites

You don't need many.  Can be cooled with wheezewort for "free."  You need to replant them though.

If you use thermo-regulator, you have to cool indirectly through gas mixing of a coolant and steam.  You continuously cool down coolant and return it to the insulated enclosure.  Use a thermometer to shut off the thermo-regulator when temperature of the gasses is below 95C as steam should already be condensing.  Using more thermo-regulator just speeds up the condensing time.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

Please be aware that the content of this thread may be outdated and no longer applicable.

×
  • Create New...